- recommended for all of the light weight hot rods with rubber mounted engines
- increases the compression to 10.5:1 using domed pistons
- best when used with a final drive of 3.36:1
- gives a steady pull from idle up to 6000 RPM
- very reliable, easy starting, no flat spots, pump gas compatible
- potential of 95 horsepower and 90 foot pounds of torque

These are suggested kits only. Mix and match as you please. Fuel injected bikes will not require carb jets or ignitions.

HQ-System 95      Evolution 1340 10.5:1 compression ratio

The following is a complete list of parts and labor required to build the Head Quarters System 95 for a 1340 Evolution performance package.

Qty  Part #                         Description

                                             HEAD WORK
1)  HVP-EV                          Your heads completely reworked, ready to bolt back on.
     HVP-EV-MCR                  (as above with mechanical compression releases installed)
1)  HQ-HEAD-BOARD    Fin Protector (heads bolted to this for shipping)

                                            CYLINDER WORK
1)  HQ-7100-C                   Bore cylinders .005" O/S
1)  HQ-CYL-BOARD        Fin Protector (cylinders bolted to this for shipping)
1) WP-K1675                    Pistons, domed, forged

                                           RECOMMENDED PARTS
1)  HQ-0023                         Camshaft

                                    Additional parts for carburetor equipped models

1)  HQ-21835                     Ignition, special HQ curves (without this, you *will* have
                                               problems)

If you want this job done you will need to print a work order to send along so we know exactly what you need.
Click the red link below to find a work order for this build and print it off.
System 95 Work Order
You can price any part or the whole job by viewing or printing off a price sheet found on the red link below.
PRICE LINK